This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Installationsprobleme auf ein Pokini z 1gb RAM

Hallo,

ich versuche auf mein pokini z mit 1gb RAM die xf Firewall (neuste Version) zu installieren, aber der bricht bei 80% ab mit der Fehlermeldung: "ERROR: Unable to install firmware".

Was kann es sein?

Kann es sein das er nur 1GB RAM hat?

Beste Grüße

Christos

This thread was automatically locked due to age.

0 Christos Vassiliou over 7 years ago

Hello,

I'm trying to install the xg firewall (latest version) on my pokini z with 1gb RAM, but it aborts at 80% with the error message:"ERROR: Unable to install firmware".

What can it be?

Could it be that he only has 1GB of RAM?

Best regards

Christos

8738.pokini_z_schaltbild.pdf

I uploaded the schematic once. Maybe it's helpful
Cancel
Vote Up 0 Vote Down

Cancel
0 HuberChristian over 7 years ago in reply to Christos Vassiliou

You definitely do not want to run an XG on a 1GB System.

1GB is the minimum required for passing the installer, but it's definitely to less (I would even go for more than 2GB). Installer checks before starting the installation whether Hardware meets Requirements, so I guess in your specific Case this is not the Issue.
Cancel
Vote Up 0 Vote Down

Cancel
0 Christos Vassiliou over 7 years ago in reply to HuberChristian

If the 1GB isn't, I wonder what it is.
Can it be that the WLAN built in disturbs?

I know that 1GB is not enough, I wanted to test it at home for the first time before I got another hardware.
Cancel
Vote Up 0 Vote Down

Cancel
0 HuberChristian over 7 years ago in reply to Christos Vassiliou

In your Case, I would start to disable any Hardware not needed (Audio, Wifi etc.) in UEFI (except the two NICs). In past there were some issues with USB 3.0 Ports on some Devices... Maybe USB 3.0 can be disabled in your case.
Cancel
Vote Up 0 Vote Down

Cancel