This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Zotac CI547 Nano - only one NIC will be recognized

Dear Sophos Community

I have a Zotac CI547 Nano and tried to install the XG software. But only one NIC will be recognized. The firmware is up to date, but without ane effect. I have read that Sophos XG does not support two different NIC types (maybe Intel and Realtek are built in?).

Do you know if it's planned to support this type of Zotac boxes? If not, on which Zotac hardware do you run the XG software? Or is it possible to run the XG firewall inside an ESXi?

Regards from Switzerland.

Martin

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 7 years ago

Hi Martin,

the Zotac website doe not specify NIC types, but going on a number of consumer devices investigated the Intel NIC will more than likely be an i219v which is not supported by XG.

I you install esxi 6.5 or similar you should see both NICs.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 Martin Berger over 7 years ago in reply to rfcat_vk

Hi Ian

Thanks. I will try with ESXi. Do you have Sophos XG up and running in ESXi?

Regards, Martin
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 7 years ago in reply to Martin Berger

Hi Martin,

no I don't, I had the management XG running on esxi 5.5. I used the ISO build for software.

I currently have an esxi 6.5 which is not licenced or powered on at the moment, so I could try if you run into issues.

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 7 years ago in reply to Martin Berger

Hi Martin,

no I don't, I had the management XG running on esxi 5.5. I used the ISO build for software.

I currently have an esxi 6.5 which is not licenced or powered on at the moment, so I could try if you run into issues.

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data