How to delete a bridge and still access device?

Gerry,

did you try to use the Wizard from top-rigth menu ?

Using the wizard you should be able to reconfigure all the network adapters.

Regards

Thanks for your reply Iferrara. I'm worried that I won't have access to the device if i delete the bridge since it has the main ip of the firewall assigned across my only two lan ports? Will this be the case and if so how should I gain access after deletion?

Gerry,

you can configure XG in routing mode and assign the proper IP and interface to the proper zone. If you lost access, you always have the console where you can change the IP and perform a factory reset.

Regards

I presume by "configure the XG in routing mode" you mean XG will still be available to access via the IP after the deletion of the bridge?

I found the command line reference but can't see a command to change the IP address on a port. When I go into the network configuration on the console , the IPV4 address it lets me set only relates to port 2 (Wan) and not the others.

Thanks very much for the info. I'll give it a go and will update here after.

Gerry,

if you want to delete the bridge, you need to assigna at least one interface to LAN zone.

Use the Wizard as described here:

https://community.sophos.com/kb/en-us/122972

WAN and LAN port must have different IP and from different subnet.

For example 192.168.1.1 and 192.168.2.1

Regards