Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HA Fault Issue on Aux Device

Hey Guys,

 

Any ideas on how to deal with this issue? I just have once license running on my Active - Passive Firewall setup. If I open up HA Settings, the Aux device says that it's faulty. Is there a sync issue or something?

 

Thanks.

 

D

 



This thread was automatically locked due to age.
Parents
  • Hi D,

    Take a look at #7 in my troubleshooting guide and DM me the following logs available in the /log directory.

    1. msync.log
    2. ctsyncd.log

    Thanks

  • Thanks! here is the ticket # : 7416698

     

    When I run the system ha show logs device it just goes idle, it doesn't give me any output.

     

    Here are the details:

     

    HA status              : Enabled                                               
     Current Appliance Key  : C31056MMF98W2D8                                       
     Peer Appliance Key     : C31056KQHC8MX1B                                       
     Current HA state       : Standalone                                            
     Peer HA state          : Fault                                                 
     HA Config Mode         : Active-Passive                                        
     Load Balancing         : Not Applicable                                        
     Dedicated Port         : Port9                                                 
     Current Dedicated IP   : 10.10.11.1                                            
     Peer Dedicated IP      : 10.10.11.2                                            
     Monitoring Port        : Port1,Port2                                           
     Auxiliary Admin Port   : Port1                                                 
     Auxiliary Admin IP     : 172.16.17.5                                           
     Auxiliary Admin IPv6   : 
Reply
  • Thanks! here is the ticket # : 7416698

     

    When I run the system ha show logs device it just goes idle, it doesn't give me any output.

     

    Here are the details:

     

    HA status              : Enabled                                               
     Current Appliance Key  : C31056MMF98W2D8                                       
     Peer Appliance Key     : C31056KQHC8MX1B                                       
     Current HA state       : Standalone                                            
     Peer HA state          : Fault                                                 
     HA Config Mode         : Active-Passive                                        
     Load Balancing         : Not Applicable                                        
     Dedicated Port         : Port9                                                 
     Current Dedicated IP   : 10.10.11.1                                            
     Peer Dedicated IP      : 10.10.11.2                                            
     Monitoring Port        : Port1,Port2                                           
     Auxiliary Admin Port   : Port1                                                 
     Auxiliary Admin IP     : 172.16.17.5                                           
     Auxiliary Admin IPv6   : 
Children