This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPPoE Configuration disconnection

Last week I've installed new XG version, I was using Astaro before.

Everything configured as in the past, same line, bt right now i've disconnection of the line, I don't know if i've to set something in LCP options, at the moment are off.

I receive in log RCP time out, port down but after no reconnection.

This thread was automatically locked due to age.

Parents

0 JanSadlik over 8 years ago

Hi,

I have PPPoE set as below and it works without problems on XG.

Regards
Jan
Cancel
Vote Up 0 Vote Down

Cancel
0 tomukasteris over 8 years ago in reply to JanSadlik

Hi Jan,

What ISP provider do you have?

Have you checked Log Viewer under System? Does it show any logs for PPPoE down?

I get a lot "Disconnect PPPoE due to LCP timeout".

I have tried different MTU sizes but still is the same.

Have changed MTU size on LAN network to match your WAN MTU size?

Regards,

Tomas
Cancel
Vote Up 0 Vote Down

Cancel
0 Davide Schipani over 8 years ago in reply to tomukasteris

Right same for me.. Same log error
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Davide Schipani over 8 years ago in reply to tomukasteris

Right same for me.. Same log error
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Davide Schipani over 8 years ago in reply to Davide Schipani

I think I found the problem related on new firmware version, tried to go back to old version and no disconnection since yesterday evening!
Cancel
Vote Up 0 Vote Down

Cancel