This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Virtual XG - Sophos 55AP - No access points pending

Hi,

I have spent about an hour reading all posts that seem relevant but have had no luck so sorry if this is repeated elsewhere. I am running an upto date Home licensed virtual XG under Hyper-V, I have dual network cards, internal nic has windows management enabled and connects into my gig switch and the external switch connects into the VDSL modem. I have no issues with web browsing or services and currently have a Sophos 55AP for testing which does have an internal IP from the XG DHCP service but does not appear under access points to authorise. I have noticed under Configure - Network that the GuestAP interface which has WiFi icon reads as unplugged, could this have anything to do with it and would I need a third physical nic?

The question is How do i use this Sophos AP as my Wireless management?

This thread was automatically locked due to age.

Parents

0 lferrara over 8 years ago

Mark,

Enable auto accept AP using console and make sure your switch is passing vlan 1 on XG LAN interface.

See the following thread:

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 Mark Harris1 over 8 years ago in reply to lferrara

So have done that and rebooted AP and it still doesnt appear as an access point to approve, completely blank. As this is a home setup I am using dumb switches so no VLANs in place, all flat network.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Mark Harris1 over 8 years ago in reply to lferrara

So have done that and rebooted AP and it still doesnt appear as an access point to approve, completely blank. As this is a home setup I am using dumb switches so no VLANs in place, all flat network.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 lferrara over 8 years ago in reply to Mark Harris1

Mark,

disconnect the AP, reboot XG and then reconnect AP again.

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 Mark Harris1 over 8 years ago in reply to lferrara

Sorry for the delay in replying. Didnt work, still dont have any access points listed, cant approve it. Anything else I should consider? I may spin up my SG and see if anything is different.
Cancel
Vote Up 0 Vote Down

Cancel
0 Aditya Patel over 8 years ago in reply to Mark Harris1

Hi Mark ,

Are you using licensed version XG or free Home version ?. If you have a Licensed version , kindly logs a ticket with support for the same and check if you are getting the same results on SG as well.
Cancel
Vote Up 0 Vote Down

Cancel
0 Mark Harris1 over 8 years ago in reply to Aditya Patel

I am using the free Home version. I spun up the SG and no luck, tried configuring DHCP option 234 via the gui but no luck. Went back to the XG which had a new firmware - updated and still no luck. Have tried adding DHCP option 234 via console but not sure on the syntax.

Still no luck - why would it not work on the SG & the XG I wonder? I dont have a complex set up, two nics on an Intel NUC - Gig desktop switch and a Sophos AP.
Cancel
Vote Up 0 Vote Down

Cancel