Share between two lans

Hi Aritides, 

Configure a LAN-ANY-LAN Fw-rule without MASQ.

Thanks

it's not working!!!

Nirmal,

remove Port1 and Port4 and try again.

Thanks

Hi;

still it didn't work. here with i attached my configuration & requirementt.4213.Firewall -Almanar DED.docx

Hi,

try to deactivated user authentication box. Helped on my side.

Best regards.

Nirmal,

can you give us more details on how those 2 networks are configured? Are them VLAN? Are they created on Cyberoam directly or they are managed by an external Layer 3 device?

A network diagram will help!

Thanks

Nirmal,

can you give us more details on how those 2 networks are configured? Are them VLAN? Are they created on Cyberoam directly or they are managed by an external Layer 3 device?

A network diagram will help!

Thanks

Thanks for everyone reply!!!! This case is closed ; i have contacted the sophos support team & Mr.Arjun Sharma  has worked the case & he has done some rule & Static route.

FYI; here I am providing you the same for your reference.

One rule has written in the Protection under firewall; like below

Source Zone : Lan  Source Networks and Devices : Internal Lan on 192.168.20.0

Destination Zones : Any  Destination Networks :  Internal Lan on 172.168.40.0 & External LAN 10.250.250.0

Rewrite source address (Masquerading) : enabled

Configuration under  Routing static route has been written

Destination IP / Netmask : 10.250.250.0

Gateway: 172.168.40.1

Interface: Port4-172.168.40.2

Distance:0

Nirman,

glad you fixed it. Next time to receive the proper help from community make sure you give more details on your infrastructure otherwise we are not able to reply and help you properly.

Regards