Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 2 answers
  • Subscribers 26 subscribers
  • Views 9271 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Scheduling updates how to

malachite

Hello Everyone,

in the past I have had experience with UTM but I'm a newbie with XG.

My scenario: 1 XG125w plus 1 AP15. Yesterday my AP received a wireless protection update during working time and all the clients were disconnected.

Is there a way to scheduling all update like in utm?

Best regards

 



This thread was automatically locked due to age.
Parents
  • 0

    Malachite,

    at the moment this feature is not available. Hope it will come soon.

    AP firmware on XG is managed bu Pattern Update and without a user interaction, RED & AP Firmware are not updated. Make sure no one has installed the pattern.

    I am using AP 10 at home and without pushing the install firmware under Pattern TAB, the AP will not receive the new firmware.

    Regards

  • 0 in reply to lferrara

    Thank you for the reply but I don't understand whats actually happens.

     

    In my logviewer I see these tree lines

     

    2017-02-11 16:16:05
    Wireless Protection
    -
    -
    Successfully sent config to AP [A40039CB0DC3A88].
    18007
    2017-02-11 16:15:38
    Wireless Protection
    -
    -
    Successfully sent config to AP [A40039CB0DC3A88].
    18007
    2017-02-11 16:14:48
    Wireless Protection
    -
    -
    new firmware detected for RED15w: 1
    17998

     

    but in the "Pattern Update" tab the last successful update for the AP firmware is 11:57:33, Jan 31 2017.

    Why this difference?

  • 0 in reply to malachite

    Sorry but the line of the red update is a mistake

Reply Children
  • 0 in reply to malachite

    Malachite,

    I think that updating the red firmware, you have updated even the wireless AP built-in. I am not sure about that (I never tried) and it does not make sense because RED Firmware should update only the "red code" while AP will update only the AP code.

    Maybe with Red that comes with built-in Wi-Fi the situation is different.

    , can you explain this updated behaviour?

    Thanks