install will not start - stuck at "Do you want to continue (y/n)"

I had a look at the specifications of your server.

1/. have you installed a second NIC

2/. have you disabled the HP special disk function because the XG software will not recognise it.

Yes, I have two NICs installed.

As the screen capture shows, it sees the disk so I'm not sure the bios config for the disk is the issue.  I'm looking into this just to be sure.

(Also, I might add that I'm not 100% certain what you mean by "special disk function".)

Yes, I have two NICs installed.

As the screen capture shows, it sees the disk so I'm not sure the bios config for the disk is the issue.  I'm looking into this just to be sure.

(Also, I might add that I'm not 100% certain what you mean by "special disk function".)

I suggest you read the specifications for your server so you can figure out whether you the special drive hardware and how to disable if you have.

Thanks.  I'll look for that.

As a test I did try my last version of the UTM install CD and that worked fine, started installing files.  

I'm still suspect of the keyboard.  I think whatever is being loaded for the keyboard to be recognized is not working.  Only logical reason it would just be sitting there at the prompt without any other errors.

I'm going to try to track down a non-USB keyboard and see if that helps.

This was the solution.  My Dell 6005 Microtower + a USB keyboard was the problem.  The USB keyboard was not recognized during the initial boot.  Replacing that with a non-USB keyboard has gotten me past the initial error above.