This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Does DHCP Relay work using a RED Tunnel?

I have a RED tunnel configured between 2 XG units but have been unable to pick up a IP address from my Windows DHCP server on the other side of the tunnel.

Can anyone confirm if this should work (I noted a option to tick if this was a IPsec VPN) and if so, what interface this needs to be bound against?

The firmware version is SFOS 16.01.1

This thread was automatically locked due to age.

Parents

0 lferrara over 8 years ago

Chris,

you can try to bind the RED interface inside the DHCP server relay options.

Let us know if it works.

Use a tcpdump port 67 or 68 to track DHCP requests packets.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 Chris Yue over 8 years ago in reply to lferrara

Hi Luk,

I will give this a try.

Can you advise on how to perform a tcpdump so I can track what is happening?
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 8 years ago in reply to Chris Yue

You can launch tcpdump port 67 as command.
Cancel
Vote Up 0 Vote Down

Cancel
0 rdebraga over 7 years ago in reply to Chris Yue

How was the test ? May I need something like this solution .

With best regards
Cancel
Vote Up 0 Vote Down

Cancel
0 Bill Roland over 7 years ago in reply to rdebraga

I have a DHCP Relay on my RED interface and it works fine for me.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Bill Roland over 7 years ago in reply to rdebraga

I have a DHCP Relay on my RED interface and it works fine for me.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data