This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SG 115 with XG MR3 firmware that is blocking external Outlook Web Access.

Hello,

I have an MR3 XG115 (used to be an SG appliance). It blocks a user from accessing both his Citrix portal and Outlook Web Access portal. Both are hosted outside this organization. You get the normal untrusted certificate, click past that, but always get a blank screen.

it doesn't appear that https scanning is in place to prevent this. Any ideas?

Regards,

This thread was automatically locked due to age.

Parents

0 lferrara over 8 years ago

Jamie,

you should be able to see, inside the logs, why that traffic is blocked. I advise you to upgrade to v16 where some certificate issues have been resolved and even log management has improved a little bit.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 Jamie Wallace over 8 years ago in reply to lferrara

Luk,

The odd thing is that the URL for the webmail site appears as "allowed" in the log viewer for the web filter. Not sure if that helps narrow it down or not.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Jamie Wallace over 8 years ago in reply to lferrara

Luk,

The odd thing is that the URL for the webmail site appears as "allowed" in the log viewer for the web filter. Not sure if that helps narrow it down or not.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Emile Belcourt over 8 years ago in reply to Jamie Wallace

Hi Jamie,

Are you doing any Application filtering on your XG?

Emile
Cancel
Vote Up 0 Vote Down

Cancel
0 Jamie Wallace over 8 years ago in reply to Emile Belcourt

There are no actual application policies in place. Sophos support did a remote session with me yesterday and did several package captures, but ultimately blamed the ISP. I called the ISP this morning and they said they're not blocking any sites on their end. Sophos support has yet to send me the capture data they promised me yesterday. So basically I'm stuck.
Cancel
Vote Up 0 Vote Down

Cancel
0 Aditya Patel over 8 years ago in reply to Jamie Wallace

Hi Jamie,

Did you check by connecting the ISP directly to the system facing the issue ? and would advise to take a PCAP for reference . if it works out then you would need to contact support with the same Service request and private message me so I may monitor from my end . Also Did you enable any scanning , does it work with Plain Firewall rule ?

Thanks and Regards

Aditya Patel
Cancel
Vote Up 0 Vote Down

Cancel