Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 21 replies
  • Answers 2 answers
  • Subscribers 29 subscribers
  • Views 1426 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Home interface issues

njak'

I switched from UTM 9.x to the (for me) new XG Home.

Its an old PC working under UTM perfect with

- 2x 1port 1Gb Cards (cant remember from which company, nothing on the cards)

- 1x 4port 1Gb Card HP NC364T

Now, after installing XG Home, the boot screen shows (see below):

Total number of interfaces: 6

but i cant connect to the firewall on any port, doesn’t matter which card.

Only if i remove the 4port card i can connect to the firewall, just want know if its the Intel problem?

be irritated because the Boot screen shows correct number of interfaces.



This thread was automatically locked due to age.
Parents
  • 0

    Hi,

    did you have any of the ports connected during installation? Do you remember which port you assigned the internal network to during installation? You can logon to the console and check configuration from that screen.

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    The HP NC364T uses the Intel 82571EB chipset, which should be supported by the kernel driver "E1000E".

    Did you try to connect to "Port 0" while installing?

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to jprusch

    no, didn’t know which port is chosen as Port0. 

Reply Children
No Data
Unfiltered HTML