Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 817 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Inbound Blocked Traffic Exception

Yogi_Bear_79

I have a rule that I use to block inbound traffic. I need to make an exception to allow to public subnets to send SMTP traffic. Attempts to allow have not been successful. In the snip I show the rule, w/o an exceptions.  I had set the source as WAN, and the Source Networks to the required subnets i wish to allow. I added SMTP to the services. I did end up leaving the Destination Zone & Networks blank. Likely my issue.  I did so because above, they are sent to ANY, yet in the exception, that is not an option. 



This thread was automatically locked due to age.

Top Replies

  • +1 suggested

    Hello Yogi_Bear_79,

    Thank you for reaching out to the community, In this scenario you may create a rule above the drop rule, with action as allow and adding the explicit zone and network with explicit services you want to allow for SMTP and you are good to go !!  

    Jump to answer
Parents Reply Children
No Data