Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 27 subscribers
  • Views 871 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPv6 on WAN is not getting address

hannesk

dear all

I have istalled SF 19 on my hyper-v W16 server. 3 virtual switches - one is connected directly with the servers NIC - for WAN.

My ISP provides IP addresses with DHCP. IPv4 - everything is OK. IPv6 should get local link address for WAN and with prefix delegation it gives real 2001:7d0  / 56 adresses

But nothing is obtained from the ISP - no local link, no address block for PD. At the same time when I look under DNS IPv6 - I see that 2 IPv6 adresses of their DNS servers are obtained.. I haven't found any other place to configure IPv6 options other than under Network

What am I doing wrong?

With best

Hannes 



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to hannesk

    Next trick, please try the rapid deployment box.

    ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to hannesk

    Hi,

    please check with  yourISP which method they use to assign IPv6 addresses, because XG does not support all methods. You might need to get  static IPv6 address and configure your XG that way.

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Hi

    This info is given by Telia Estonia:

    IPv6

    For internet interface will be given IPv6 address with the help of the Prefix Delegation (PD) from Telia EE address pool  2001:7d0  / 56.

    WAN interface will not given IPv6 address, local link address will be used (unnumbered WAN)

    • IPv6 routing info comes from Routing Advertisment (RA) 
    • PD ja DNS server aadresses will be sent through  DHCPv6
      I used wireshark and saw that local link was given to my FW WAN, but when I enter this address mmanually, SFW says that local link cannot be the WAN address
      So it seems that I have to find another similar software for my home firewalling
      With best
      Hannes 
  • 0 in reply to hannesk

    At this stage XG does not use PD. Local link can only be a gateway. You need 2001:7d0:: address range.

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML