Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 2 replies
  • Subscribers 28 subscribers
  • Views 430 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC-S2S / SSL-VPN-S2S / IPSEC-Remote Access -- No Routing Required

Manish Chawda

Hi,

I have a question as to why there is no routing rule to be configured for the following :

IPSEC Site To Site / Remote Access

SSL-VPN Site To Site

Please advise

Manish



This thread was automatically locked due to age.
Parents
  • +1

    If you are directly connected, you don‘t need any routes.

    Just look at the routing table after setzing up a VPN like that.

    No additional routes need to be set by you.

    If you have a more complex setup with more segments on one or more sites, then this is a different scenario.

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

Reply
  • +1

    If you are directly connected, you don‘t need any routes.

    Just look at the routing table after setzing up a VPN like that.

    No additional routes need to be set by you.

    If you have a more complex setup with more segments on one or more sites, then this is a different scenario.

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?