Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 2 replies
  • Subscribers 28 subscribers
  • Views 428 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC-S2S / SSL-VPN-S2S / IPSEC-Remote Access -- No Routing Required

Manish Chawda

Hi,

I have a question as to why there is no routing rule to be configured for the following :

IPSEC Site To Site / Remote Access

SSL-VPN Site To Site

Please advise

Manish



This thread was automatically locked due to age.
  • +1

    If you are directly connected, you don‘t need any routes.

    Just look at the routing table after setzing up a VPN like that.

    No additional routes need to be set by you.

    If you have a more complex setup with more segments on one or more sites, then this is a different scenario.

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

  • +1

    The XG builds the routes automatically from the information specified in the VPN connection when you set it up.

    E.g. for an IPsec site to site, you specify local and remote subnet. The XG then inserts routes for that traffic when the connection is made.

Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?