Sophos XG doesn't boot on DELL T40

What type of disk are you trying to install too?

well it's kinda funny. I have just figured it out, I can connect with web gui through lan port, but the screen attached to the devcice is empty. When I have installed it to an old Fujitsu device, it was normal. But now it's weired. I'm using SSD SATA  disk.

Hi,

that means there XG does not contain a driver for that inbuilt console. Thank you, because I always wondered about that feature on some of the MBs I have contemplated using in the past. Does that chip have an inbuilt display chip?

ian

Hi,

Yes, it does. I have previously installed Windows on that PC. Now on the monitor screen that connected to the PC is showing 'Booting `18_5_1_326'   on the upper-left corner, the rest screen is dark 

Update! It ran smoothly for few hours then automatically disconnected. I have tried a lot to get connected by changing port's gateway IP, but nothing. Then I've reinstalled it again, same as old, screen shows only  'Booting `18_5_1_326' , and GUI works for few hours, then lost connection again. I am now returning the PC and buying a 2nd hand Fujitsu PC.

Update! It ran smoothly for few hours then automatically disconnected. I have tried a lot to get connected by changing port's gateway IP, but nothing. Then I've reinstalled it again, same as old, screen shows only  'Booting `18_5_1_326' , and GUI works for few hours, then lost connection again. I am now returning the PC and buying a 2nd hand Fujitsu PC.

Hi,

I have the same problem, did you find any solution?

Thank you,