This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VPN Error

Hi everyone,

I have a VPN between six units with all ports freed but a specific application does not work. I can see the port open but an unknown error is displayed. This happens in only one of the units (I have another 4 connected and without failures). Any suggestions of what I should look for?

Regards

This thread was automatically locked due to age.

Top Replies

FormerMember over 4 years ago +1

Hi Luiz Souto , Thank you for reaching out to the Community! Did you configure the IPsec site to site VPN between these firewalls? Is this application hosted on one of the locations? Would it be…

Parents

0 FormerMember over 4 years ago

Hi Luiz Souto,

Thank you for reaching out to the Community!

Did you configure the IPsec site to site VPN between these firewalls? Is this application hosted on one of the locations?

Would it be possible for you to share a network diagram and explain the traffic flow to the application you're having an issue accessing?

Thanks,
Cancel
Vote Up +1 Vote Down

Cancel
0 Luiz Souto over 4 years ago in reply to FormerMember

Resolved, licenses were not correctly applied to boxes.

Thank you for your attention
Cancel
Vote Up +1 Vote Down

Cancel

Reply

0 Luiz Souto over 4 years ago in reply to FormerMember

Resolved, licenses were not correctly applied to boxes.

Thank you for your attention
Cancel
Vote Up +1 Vote Down

Cancel

Children

No Data