Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 1 reply
  • Subscribers 26 subscribers
  • Views 452 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Link Failover

Xebato

Hello,

I would like to implement fail over between two locations. The main link is a direct Ethernet link and the second link is IPsec VPN.

I have also found the KB-000035833 which match my requirements however I have the following question : The KB-000035833 is based on v17.X and I have to use the following command

Syntax: system link_failover add primarylink <MPLSPort> backuplink vpn tunnel <VPNLink> monitor PING host <RemoteIP>

Is the same apply to v18 ? or I can do the failover using a better way ?

Best Regards,

Xebato



This thread was automatically locked due to age.
Parents
  • FormerMember
    +1 FormerMember

    Hi ,

    Thanks for reaching out to the Community! 

    The commands provided in the KBA aren’t firmware version-specific; you could use them on to v18 as well. It monitors the remote device through TCP or ICMP, and link failover selection will be based on the remote device's status.

    Thanks,

Reply
  • FormerMember
    +1 FormerMember

    Hi ,

    Thanks for reaching out to the Community! 

    The commands provided in the KBA aren’t firmware version-specific; you could use them on to v18 as well. It monitors the remote device through TCP or ICMP, and link failover selection will be based on the remote device's status.

    Thanks,

Children
No Data