Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 27 subscribers
  • Views 597 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ability to specify WAN and LAN nics on specific ports at setup time.

Jay W

Are there any plans to allow to specify WAN and LAN default device from the console itself?

Currently it always defaults to port1 and port2 which can be very frustrating when using on a VMs with physical and virtual interfaces especially when changing (physical) order of NICs is not supported post installation.

Ability to define which NICs are LAN and WAN would resolve this problem. ( Or alternatively.. allow changing the order of interfaces and base it's configuration on MAC address rather than PCI order ).

Thanks,



This thread was automatically locked due to age.
Parents
  • 0

    Hi Jay,

    as a comment, the function must be in the software already just not on an easy accessible method because if you install an XG ISO on a XG Sophos hardware the ports are assigned in different order to the Sophos hardware specific installation software.

    Ian

Reply
  • 0

    Hi Jay,

    as a comment, the function must be in the software already just not on an easy accessible method because if you install an XG ISO on a XG Sophos hardware the ports are assigned in different order to the Sophos hardware specific installation software.

    Ian

Children
No Data