This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Home on SG115rev3

Hi,

I tried to install XG Home on an old SG115 Rev. 3. After deleting all Partitions the Installation of the Software ISO went fine, but at the end I'm not able to connect to the firewall over any Ethernetport. Only Eth0 is establishing a connection but no IP via DHCP. Also when I set the PC manual to 172.16.16.17/24 i cannot open 172.16.16.16:4444 or ping 172.16.16.16

I also installed the HW ISO for testing and everything works fine... so I don't think its a hardware failure.

I tried SW-17.5.14_MR-14-1-714.iso and SW-18.0.1_MR-1-Build396-396.iso

Did I forget something?

Greets

Daniel

This thread was automatically locked due to age.

0 rfcat_vk over 4 years ago

Hi,

the port numbering changes, so it will be a plug and play to find the correct port.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 Daniel79 over 4 years ago in reply to rfcat_vk

Hi, thanks for your answer,

I tried it but only eth0 comes up... no link on any other port.

Greets

Daniel
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 4 years ago in reply to Daniel79

During the installation process you get access to the cli, when you install again, check the network settings. To get a wan link as well as a lan link you will need active connections on two interfaces.

ian
Cancel
Vote Up 0 Vote Down

Cancel