Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 27 subscribers
  • Views 1327 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridge not connecting to router

Kolt Litrenta

I just finished installing Sophox XG on Hyper-V.  When my laptop is connected to the firewall's LAN, I do not get any internet.  My WAN does not seem to be communicating to my router (or even my switch if plugged into that).  I don't know if I need to make a new policy (I haven't touched the rules/policies).  The network config is all correct, the gateway IP is set to the correct IP of my router.  Any ideas?



This thread was automatically locked due to age.
  • 0 in reply to rfcat_vk

    Hello - here are some screenshots I got of the management panel.  Still no link to the internet but the LAN side seems to be working properly.  I am still puzzled why this is not working, frustrating but I am still trying

     

     

    also I am using the Unifi gateway in combination with my other Unifi access points. 

     

    Thank you

  • 0 in reply to Kolt Litrenta

    Hi,

    what you have shown indicates there is no connection between the XG and the Unifi gateway.

    You can still use the Unifi gateway behind the XG and gain the protection you are after.

    Ian

  • 0 in reply to rfcat_vk

    Hello, I have decided to do that - put the USG behind the XG.  Right now, without the USG, XG is working great acting as the main router, certainly a lot of configuration for advanced stuff but learning and trying it out is the purpose.  Now it's all about integrating the USG between the XG and the rest of the network which comes new problems as I have to do some advanced configuration to place the USG in 'transparent mode' to for the internet to pass through it, which I am going to try tomorrow. 

     

    Thank you