This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

User portal not accessible to WAN

Yendor over 5 years ago

Maybe I am missing something but users can not access the user portal from the WAN.

I thought it would be available by default via port 443 as long as the Device Access/ACL service was enabled for WAN.

This thread was automatically locked due to age.

Parents

0 lferrara over 5 years ago

Yendor,

can you share the device access from Administration menu?

Also check which port is User Portal using inside Administration > Device settings.

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 Yendor over 5 years ago in reply to lferrara

can you share the device access from Administration menu?

Also check which port is User Portal using inside Administration > Device settings.

443

I have also tried 4443 and still nothing. I am able to access the user portal from the internal IP while local however I think when downloading the VPN settings from the user portal it does not get the right information and it uses the internal IP in the configs? is this correct?
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 5 years ago in reply to Yendor

The XG is behind another router device?

For the vpn, did you configure the dns/public ip in the ssl vpn settings under VPN menu?
Cancel
Vote Up 0 Vote Down

Cancel
0 Yendor over 5 years ago in reply to lferrara

The XG is behind another router device? NO

For the vpn, did you configure the dns/public ip in the ssl vpn settings under VPN menu? What do you mean by the DNS/Public IP?

I followed the setup guide below and there was nothing said about DNS. Is this DNS for internal resolution?

community.sophos.com/.../122769

I'm trying to connect to the vpn on my mobile device using OpenVPN and I'm getting "Transport Error TCPv4 connect error on [public IP]:8443 Connection Refused
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 5 years ago in reply to Yendor

I mean this section:

Configuring advanced SSL VPN settings

in the KB.

Try to switch between TCP to UPD on the same TAB and try again.

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 5 years ago in reply to lferrara

PS: SSLVPN and User Portal can be used on the Same Interface / Port.

So you could switch both to 443.
Cancel
Vote Up 0 Vote Down

Cancel
0 Yendor over 5 years ago in reply to LuCar Toni

SO I figured out why my SSL VPN was not working. I did a tcpdump and noticed that the port was being forwarded to my NAS via my DNAT rule. Im not sure why at this point however I know when I disable my DNAT runle my VPN connects.

Anu IDEAS? Would it have to do with the reverse proxy I set up on the Synology NAS to get the synology DSM login page working?
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 5 years ago in reply to Yendor

Yendor, you cannot have 2 services on the same port.

Change the SSL VPN port to another port, re-download the VPN configuration and reconnect.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 lferrara over 5 years ago in reply to Yendor

Yendor, you cannot have 2 services on the same port.

Change the SSL VPN port to another port, re-download the VPN configuration and reconnect.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

User portal not accessible to WAN

Configuring advanced SSL VPN settings