Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 5349 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

firewall Port 443 open on WAN

breda

Hi, we just finished setting up our XG125, we noticed after a port scan port 443 is open, I found this https://community.sophos.com/products/unified-threat-management/f/network-protection-firewall-nat-qos-ips/38279/port-443-open-from-outside-but-no-rule# 

 

but I can't find the  Go System >> WebAdmin Settings and change Allowed Networks to Internal. If port 443 is available from the outside, you probably have Allowed Networks set to Any

 

Thanks 



This thread was automatically locked due to age.
Parents
  • +1

    Hi Shon,

    This description is from Sophos SG... and you are within SG-Usergroup here ... but i'll try to help.

    With XG you define administrative access at interface level. Than have a page where you see admin-access (ping/ssh/webadmin) within a table.
    But 443 looks like a user-portal...
    Try: Administration > Device access and check the user portal and HTTPS service for WAN zone

    Your XG has bound the scanned IP directly to the device ... or do you use NAT/portforwarding/exposed hsot/ ... at the provider router?

  • 0 in reply to dirkkotte

    Hi, Dirk

     

    thanks for the help we don't' have any Servers on the network, it's SOHO setup we do have Ring cameras and  Amazon Fire TV Streaming devices  on the network,  I don't have a lot of IT Networking experience  still learning  

     

    Here is a screenshot of the  Administration Device access 

     

     

  • 0 in reply to breda

    Thanks for the help I uncheck  WAN on User Portal  and it closed 443

  • +1 in reply to breda

    Hi,

    you need to untick those boxes in the WAN access line.

    Ian

Reply Children
No Data