This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How can i bridge an interface to RED from XG

i have an XG version 17.5.7...we dont have any sophos wireless devices except for one of our remote offices that has RED15W

the RED has its own subnet, and i have another subnet at the main location i want it to be used for wifi clients at that remote location and keep the main subnet they are using now for the ethernet connections

i added a wireless network through the XG but the bridge didnt show up with the interface list, if i add it manually by Bridging the RED with the local subnet i need to pass to this location will this effect the ethernet connections there?

This thread was automatically locked due to age.

Parents

0 LuCar Toni over 6 years ago

Can you draw a little picture of what you actually want to do?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 LuCar Toni over 6 years ago

Can you draw a little picture of what you actually want to do?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 leo hamel over 6 years ago in reply to LuCar Toni

Yes ...the red color is what i want to implement in this diagram

thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 6 years ago in reply to leo hamel

I guess ,that is not possible..

You cannot bridge the Traffic of a AP into another Subnet.

Basically bridge to AP LAN is build for this, but AP Lan would be 192.168.5.0/24 in that case.

The interface is not selectable.

If you would bridge the RED15w Interface into your interface 1, your RED would get the same network, so basically you could use the same network on wireless.
Cancel
Vote Up 0 Vote Down

Cancel
0 leo hamel over 6 years ago in reply to LuCar Toni

thanks!

i will do it like this, but i want to make sure am doing it right

is there any documentation about enabling AP on RED15w?

the whole setup seems to be confusing
Cancel
Vote Up 0 Vote Down

Cancel