This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Add device for fingerprint

greetings,

i hope anyone could help me,

i have setup a server for time attendance management with IP 20.1.1.29 in local network and i try to add a device for fingerprint in another branch with an IP address 192.168.2.11, i can ping to 20.1.1.29 from outside local network also ping 192.168.2.11 from inside local network. what shall i do ??

This thread was automatically locked due to age.

0 rfcat_vk over 6 years ago

Pleas provide a network diagram to help understand what you sew trying to achieve because you description is a little confusing.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 Morkos Geoege over 6 years ago in reply to rfcat_vk

8880.Blank Diagram - Page 2.pdfi can ping each ip from the next site and when i try add the device ip 192.168.2.11 for the server 29 the error come with zero found
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 6 years ago in reply to Morkos Geoege

Hi,

I have reviewed your diagram and it doesn't really add anything extra.

Is the server in a DMZ at HQ, do you have VPN running between branch and HQ.

If it is in a DMZ what is your rule allowing traffic into the DMZ.

Do you have a rule in the branch XG allowing the specific address to be sent over the VPN?

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 Morkos Geoege over 6 years ago in reply to rfcat_vk

i will check all this tests then return to you by feedback
Cancel
Vote Up 0 Vote Down

Cancel