This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos XG125 Routing

Looking for some guidance.......

My company just bought a small mfg company and we are in the process of on boarding them. They have a Sophos XG125, and we would like to setup VPN tunnel back to the Corp. Office.

The VPN part seem straight forward and shouldn't be an issue.

https://www.sophos.com/en-us/medialibrary/PDFs/documentation/SophosFirewall/Pocket-Guides/Establish-IPsec-VPN-Connection-between-Sophos-and-PaloAlto.pdf

My concern is that there is no Layer 3 device behind the firewall. There is a lancom GS2352p which seem to be layer 2 only.

My question is can the XG125 do any routing? Normally I would throw a layer 3 device on the other side of the firewall. But since the XG125 is also the AP Controller trying to figure out the best process.

thanks

Mark

This thread was automatically locked due to age.

0 Aditya Patel over 6 years ago

Hello Mark Steinbach,

It does seem you wish to connect a VPN with another L3 device with VPN IPsec site to site capability. XG has to be gateway mode to connect with such device and connect a channel between them. As for routing, yes it should allow the traffic between two defined networks.
Cancel
Vote Up 0 Vote Down

Cancel
0 Mark Steinbach over 6 years ago in reply to Aditya Patel

So i was hoping for more information on this topic.does anyone have documentation on this process?

thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 Aditya Patel over 6 years ago in reply to Mark Steinbach

Hello Mark Steinbach,

We do have several documents on the subject but how you wish to connect is up to you.

Here is the link to documents and pockets guides for your configuration.
Cancel
Vote Up 0 Vote Down

Cancel