Two Sites Wired Connectivity between Sophos XG to Fortunate Firewall

Hi Shashi Bhushan Sagar 

You have a number of available options for this situation.

Are you looking to set up an IPsec site to site tunnel? Note that you may have to apply NAT due to the overlapping local subnets between your Site A and Site B.

• Sophos XG Firewall: How to apply NAT over a Site-to-Site IPsec VPN connection

Regards,

Hello,

I know there is a option for site to site vpn configuration.  But I want to connect it without any VPN. As I mentioned there is a direct connection between sites through wire. I have connect it one port and created a new zone name P2P. That zone is part of Lan.

Regards,

SBS

Hello Shashi Bhushan Sagar,

Since you have similar networks on both ends the setup would not work. If you have a P2P connection then the local route i.e. Kernal route will take higher precedence over static or dynamic routes. So if you try to communicate with the remote network then the traffic will not be forwarded to P2P connection.

I would strongly advise you to either change the network on one of these sites or connect IPsec and use NAT transversal to map with another/virtual subnet. 

Hello Shashi Bhushan Sagar,

Since you have similar networks on both ends the setup would not work. If you have a P2P connection then the local route i.e. Kernal route will take higher precedence over static or dynamic routes. So if you try to communicate with the remote network then the traffic will not be forwarded to P2P connection.

I would strongly advise you to either change the network on one of these sites or connect IPsec and use NAT transversal to map with another/virtual subnet.