This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

adding another subnet to XG

Hi Guys.

I have my main subnet applied to my wan interface.

My ISP has assigned me another subnet to use on separate interfaces. How do I go about doing this when the machine I want to connect to the interface has the public IP address to be used? This is quite easy on a Mikrotik. I just assign the new subnet to an interface, and then directly connect whatever I need on that interface.

This doesn't seem to be the case on an XG?

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 6 years ago

Hi,

it is exactly the same on the XG. What size subnet, I assume it is for internal use?

Your firewall rule would not require a MASQ for the new range is used internally.

Ian

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 HaydenKirk over 6 years ago in reply to rfcat_vk

It's a public /30 range
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 6 years ago in reply to HaydenKirk

Thank you, but you didn't say where you are going to use it. That small would indicate an external interface unless you are setting ups DMZ for a server?

Ian

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 HaydenKirk over 6 years ago in reply to rfcat_vk

Correct. So apply the subnet to that interface, set as DMZ, then set the second address on the device plugging into the port?
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 6 years ago in reply to HaydenKirk

Correct. Then setup a business rule to allow external access.

You will also need another firewall rule to allow internal users to access the server.

Ian

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 6 years ago in reply to HaydenKirk

Correct. Then setup a business rule to allow external access.

You will also need another firewall rule to allow internal users to access the server.

Ian

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data