Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 849 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

about connexion speed

sadiki elmustapha

hello everyone

       i want help please

         i did a migration of two firewalls, i changed the cisco firewall 5020 by sophos xg 230, all of it goes well about the rules,

         but i found that the speed of the connection is slow by bringing the cisco

          into the LAN to WAN rule i have not enabled neither IPS nor Traffic Shapping nor filtering

          I want to know and there is an option that allows us to control the bitrate use by the connection

thanks in advance



This thread was automatically locked due to age.
  • 0

    Hi sadiki ,

    You may check few settings that might identify the connection issue.

    Step 1:

    Check if there are any drops or errors on the interface

    Go to Option 4>  show network interfaces

    You should expect the results as shown below. 

    RX State: packets:259526 bytes:390574475 (372.4 MiB)
                               errors:0 dropped:0 overruns:0 frame:0
                     TX State: packets:101704 bytes:5887110 (5.6 MiB)
                               errors:0 dropped:0 overruns:0 carrier:0

    Step 2:

    Option 4> system diagnostics utilities bandwidth-monitor 

    Debault will show live bandwidth utilization.

    Toggle 'u' twice , you should see e/s i.e Error per Second.

    It should be 0.