No i installed SFOS again using the Hardware iso, so it's up and running again. My trial has expired so I might have to migrate my UTM9 license (there's only 6months left anyway).. Hmm i don't think there's a hidden partition since it could start the firmware loader with an unplugged harddrive.. There must be some kind of little storage partition in there.
The Sophos XG can be successfully installed on a Sophos UTM 120 rev. 5 (2GB RAM) appliance but it was bit tricky!
The CDROM was found and accepted as boot medium but the appliance was catched in a boot loop. So I was forced to flush the BIOS configuration (via jumper setting on the mainboard) to get it boot from the CDROM. After that trick the installation was possible and successful.
Then I faced the next problem: The appliance was up and via ICMP reachable, but TCP4444 was definitely down. I rebooted the device servel times and later on I just waited about 10 minutes and then TCP4444 became surprisingly reachable.
I've (re)installed Copernicus/XG many times since the first published Beta version (August 2015), on my office UTM 110/120 device.
Advices from my experience:
- There is no need to use external CD/DVD device, burn the ISO image on an USB key.
- Use Win32 Disk Imager software for that task, don't experiment with Rufus and others (suggested from managers/developers during Beta phase on old astaro.org forum).
- UTM120 is very slow, so it is normal to experience latency between ping and accessing web console. Be patient, it can last several minutes. I was also being nervous in first couple times, doing hard reboots...etc...until realized that it is normal for XG initialization on this appliance..;). If you have VGA monitor connected directly you can see that boot procedure (admin prompt) is being finished in less than a minute, but that is misleading. If you login and press any menu button you will be presented with message "Please wait, system is still initializing".
Using the Software version or Hardware version? When I tried to install the software version of UTM on my SG it displayed an error and told me to install the hardware version...
So I had to install the hardware version then delete the asg file to use my home license.. same case with XG?
I have installed the software version on the UTM 120 rev. 5 and there was no order to use the hardware version. Maybe because I have deleted all partitions first?
I did the same on my UTM 120 Rev 5.. I powered off my Hardware UTM 9 version and installed the Software XG without deleting any partitions. So i guess it doesn't matter.
XG installer should wipe all of the partitions anyway (there is a warning to accept before continuing).
p.s Nobody here mentioned Beethoven "Per Elisa" theme from UTM120 internal beeper, after the installation was finished....it scared me the first time...[;)]
