The Sophos XG can be successfully installed on a Sophos UTM 120 rev. 5 (2GB RAM) appliance but it was bit tricky!
The CDROM was found and accepted as boot medium but the appliance was catched in a boot loop. So I was forced to flush the BIOS configuration (via jumper setting on the mainboard) to get it boot from the CDROM. After that trick the installation was possible and successful.
Then I faced the next problem: The appliance was up and via ICMP reachable, but TCP4444 was definitely down. I rebooted the device servel times and later on I just waited about 10 minutes and then TCP4444 became surprisingly reachable.
Using the Software version or Hardware version? When I tried to install the software version of UTM on my SG it displayed an error and told me to install the hardware version...
So I had to install the hardware version then delete the asg file to use my home license.. same case with XG?
I have installed the software version on the UTM 120 rev. 5 and there was no order to use the hardware version. Maybe because I have deleted all partitions first?
I did the same on my UTM 120 Rev 5.. I powered off my Hardware UTM 9 version and installed the Software XG without deleting any partitions. So i guess it doesn't matter.
I did the same on my UTM 120 Rev 5.. I powered off my Hardware UTM 9 version and installed the Software XG without deleting any partitions. So i guess it doesn't matter.
