AP55C cannot select Wireless Networks

Hi Martin,

Edit: See GavinDaniels response below

Thanks,

Hi,

Customer only have this one AP55c, which I took from another customer running XG 17.1.3, where it was working fine.

Only difference is that this customer have High Availibility activated, and the AP55C sits behind RED connection (RED50).

When I delete it, it pops up again for adoption, all is good, only problem is that I cannot select any WLANs, even though I have created 3 of them.

AP is flashing green as normal when adopted.

Hello

I would say that you have your Wireless Networks in another group, and because you are attempting to assign them to networks in the Default Group, nothing is showing.

Check in the 'Access Point Groups' that the networks are in the default group, and the default group is enabled.

Regards

Gavin

You are correct! - Great spotted!

Group on the Ap was default group, this group was empty, all I had to do, was to choose "None" as group, and the I could assign WLANS.

Funny my XG at home, this was somehow in "None"  -group by default, and therefore I did not see that befpore (Note: I used UTM -> XG Conversion appliance)

Thanks!!

Did you delete it from the first customer before removing it?

Ian