This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSL VPN Remote Access: I am unable to access files on my network from a remote location

I am unable to access files on my network from a remote location.

 

I downloaded the agent from my user portal, and I was able to connect. In fact it assigned me an IP address from the range I put in the settings on the XG firewall.

 

But I cannot access files in my office from my PC with this VPN agent. It brings no error message.

I need assistance with this.

 

Thanks. 

 

PS: I AM quite new here. Been asking too much questions though. 



This thread was automatically locked due to age.
Parents
  • Hi,


    Good day!

     

    Have you created a Firewall rule that allows resources to be accessed on your VPN? If not, you have to create a firewall rule from LAN to VPN and VPN to LAN. See instructions below:

     

    1. Source host = Any(This is initial, you could make it specific)

    2. Destination host = Any(This is initial, you could make it specific)

    3. Services = Any(This is initial, you could make it specific)

     

    NOTE: As default and suggested, no NAT is needed.


    Warm Regards,

    Deo Angelo Lim

Reply
  • Hi,


    Good day!

     

    Have you created a Firewall rule that allows resources to be accessed on your VPN? If not, you have to create a firewall rule from LAN to VPN and VPN to LAN. See instructions below:

     

    1. Source host = Any(This is initial, you could make it specific)

    2. Destination host = Any(This is initial, you could make it specific)

    3. Services = Any(This is initial, you could make it specific)

     

    NOTE: As default and suggested, no NAT is needed.


    Warm Regards,

    Deo Angelo Lim

Children