Sophos Firewall

Discussions Connecting a printer to a Sophos XG 210

Sophos Firewall requires membership for participation - click to join

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connecting a printer to a Sophos XG 210

David Ibegbu over 7 years ago

Hello,

I have a Sophos XG 210 in my network and currently i want to connect my network printer to it for everyone usage.

What i did:

1. I connect the printer to port 6 of my sophos XG 210 and move the port to the LAN zone

2. I set it to DHCP so that it can be on the same subnet like my LAN

3. I set a firewall rule going from LAN -> LAN.

But up till now, the network printer is not getting IP and i cant reach it.

Can anyone advise how best to advertise the printer on the network?

This thread was automatically locked due to age.

Parents

rfcat_vk over 7 years ago

Why not just connect the printer to the LAN instead of going about the connection the hard way?

LAN to LAN will not work, you are sending the traffic to itself.

If you want the printer on a different physical connection then you will need a different IP address for the interface and the network.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
David Ibegbu over 7 years ago in reply to rfcat_vk

That is my network map below.

Port 1 -> LAN(Wifi)

Port 2 -> WAN

Port 6 -> Printer.

After using the setup i typed up there, i decided to change the setup.

I bridge port 1(LAN) and Port 6(Printer) together.

Still, i still cant reach the printer.

Is there any other thing i can do or omitting.

NB: I want to eliminate the use of switch.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
Alessandro Massi over 7 years ago in reply to David Ibegbu

Very strange, if the ports 1 and 6 are in the same zone, LAN in this case, IP addresses should communicate. You don't need rules in the zone is the same... so, are the port 1 and 6 in the same zone? you can reach the printer with ping?
Cancel
Vote Up 0 Vote Down

Cancel
rfcat_vk over 7 years ago in reply to Alessandro Massi

His problem is he has the same IP address range on both ports.

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Reply

rfcat_vk over 7 years ago in reply to Alessandro Massi

His problem is he has the same IP address range on both ports.

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Children

David Ibegbu over 7 years ago in reply to rfcat_vk

What do you think is the best solution?
Cancel
Vote Up 0 Vote Down

Cancel