Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP10 performance - throughput

I rebuilt one of my UTMs because I could not find a rule that not working correctly.

Enabled the AP10, did all the magic in ssh and only increased the connection speed to 72mb/s even though the specifications shows 150mb/s. Not sure about 150mb/s on a device that has a LAN interface of 100mb/s?

Now I have seen faster connections in the past, but not with any of the most recent UTM software releases. Am I daydreaming?

Your thoughts and suggestions appreciated.



This thread was automatically locked due to age.
Parents
  • Hi,

    It is tough to consider that 100BASE TX, will provide a throughput of 150mbps! Where did you checked the specifications that shows 150mb/s?

    Thanks

    Sachin Gurung
    Team Lead | Sophos Technical Support
    Knowledge Base  |  @SophosSupport  |  Video tutorials
    Remember to like a post.  If a post (on a question thread) solves your question use the 'This helped me' link.

  • anyone of the websites that shows specifications for an AP10 including the Sophos AP10 manual as written and published by Sophos. If you like I can post screen shot of the manual or post a link to the manual.

    Ian,

    home UTM 9.x running in ESXi 6 e3-1275v2

    AP55c and AP10 (courtesy Astaro)

    Three other UTMs, SUM and SFM in hibernation

    XG 15.x MR3 in hibernation

Reply
  • anyone of the websites that shows specifications for an AP10 including the Sophos AP10 manual as written and published by Sophos. If you like I can post screen shot of the manual or post a link to the manual.

    Ian,

    home UTM 9.x running in ESXi 6 e3-1275v2

    AP55c and AP10 (courtesy Astaro)

    Three other UTMs, SUM and SFM in hibernation

    XG 15.x MR3 in hibernation

Children