Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 115 replies
  • Subscribers 1 subscriber
  • Views 71893 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bad throughput after 9.30*

Lionking
My guest WLAN (separate zone) is unusable after upgrading to 9.301. My other two WLANs that are bridged to LAN works fine.


This thread was automatically locked due to age.
Parents
  • 0
    The workaround intended by the article Romano links to fixes the speed problem.  I say "intended" because the instruction given in the article is incorrect.  The following command gets the speed back up (100% with MTU 1450, but only 66% at 1500). Run as root:
    /sbin/ethtool -K wlan0 tso off

    Replace "wlan0" with "wlan1" etc. to handle each of your "Separate Zone" SSIDs.  Must be done after every reboot until the fix arrives in 9.308.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson 

    /sbin/ethtool -K wlan0 tso off

    Replace "wlan0" with "wlan1" etc. to handle each of your "Separate Zone" SSIDs.  Must be done after every reboot until the fix arrives in 9.308.


    Am I correct, there is NO fix for this in 9.308 [:S]

    -----

    Best regards
    Martin

    Sophos XGS 2100 @ Home | Sophos v19 Architect

Reply Children
Unfiltered HTML