Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bad throughput after 9.30*

My guest WLAN (separate zone) is unusable after upgrading to 9.301. My other two WLANs that are bridged to LAN works fine.


This thread was automatically locked due to age.
Parents
  • @home 120 + ap10
    @work sg325 + ap30's

    @home 1400 mtu (normal speeds) other value here are d/l with 2-60kb/s instead of 120mb/s
    @work 1432 mtu (normal speeds) other value here are d/l with 2-80kb/s instead of 100mb/s
  • I already posted this a while ago in the beta forum. 

    https://community.sophos.com/products/unified-threat-management/astaroorg/f/82/t/65805

    Probably this got not fixed, if still issues around. However - I´m running my separate zone networks since october (since I posted that issue - totally forgot, that I´m not running default MTU since 1,5 month) with a MTU of 1280, which seems to behave quite nicely in view of low latency and high throughput...

    EDIT: Just tested it again with 9.303 and AP100. MTU 1500 performsnow better than 1280 - get full Internetbandwidth of 50/5 through the air with good ping times of 14ms (with web proxy, IPS, AppControl, ATP and everything else on ;o)) Will test later with a AP10 too to make sure it´s not an AP related issue...

    Edit (again 15mins later...): Ok...thoughput started to suffer again 10-15mins later. Got again only ~1,5MBit/s download via eparate zone. Went back to MTU of 1280...Will point the WIFI dev team to that matter again...
Reply
  • I already posted this a while ago in the beta forum. 

    https://community.sophos.com/products/unified-threat-management/astaroorg/f/82/t/65805

    Probably this got not fixed, if still issues around. However - I´m running my separate zone networks since october (since I posted that issue - totally forgot, that I´m not running default MTU since 1,5 month) with a MTU of 1280, which seems to behave quite nicely in view of low latency and high throughput...

    EDIT: Just tested it again with 9.303 and AP100. MTU 1500 performsnow better than 1280 - get full Internetbandwidth of 50/5 through the air with good ping times of 14ms (with web proxy, IPS, AppControl, ATP and everything else on ;o)) Will test later with a AP10 too to make sure it´s not an AP related issue...

    Edit (again 15mins later...): Ok...thoughput started to suffer again 10-15mins later. Got again only ~1,5MBit/s download via eparate zone. Went back to MTU of 1280...Will point the WIFI dev team to that matter again...
Children
No Data