This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP30 Not Detecting

Hi,

I just fired up a 220, and tried to add an AP30 to it.
I plugged in the AP30 on eth4.  The interface on eth4 has a static IP in the same range as the UTM.

I set up DHCP on eth4 to assign an IP to the AP30.  I see in the DHCP leases that it received the IP, however I can't ping it from the UTM device and it doesn't show up as a pending access point.

I'm stumped... help??

This thread was automatically locked due to age.

Parents

0 GuyFawkes over 11 years ago

Hi SpectreJCB,
connect the AP30 with your LAN (for example a switch, which is connected to eth1).

After this, go to wireless protection and accept the Internal LAN (listening interface / LAN for new APs). You can also accept the "eth4 LAN". Then I expect that your UTM will find the new AP.

If you have furthermore problems, please flash you AP with the sophos flashing utility:
How to recover a Sophos RED device / Sophos Access Point

Nice greetings
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 GuyFawkes over 11 years ago

Hi SpectreJCB,
connect the AP30 with your LAN (for example a switch, which is connected to eth1).

After this, go to wireless protection and accept the Internal LAN (listening interface / LAN for new APs). You can also accept the "eth4 LAN". Then I expect that your UTM will find the new AP.

If you have furthermore problems, please flash you AP with the sophos flashing utility:
How to recover a Sophos RED device / Sophos Access Point

Nice greetings
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data