This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[8.102] Strange outgoing traffic from AP10s to 1.2.3.4 through 2712 port

Hello,
I have 5 ap10. From all of them I see strange outgoing traffic TO 1.2.3.4 ip address (it is a real ip not just an invented one) through 2712 destination port.

What is it?!? This port is NOT opened by my packet filter rules... In some situation the outgoing traffic is high.

see screenshot

This thread was automatically locked due to age.

0 BAlfson over 14 years ago

Isn't that the port+address the RED uses to do its magic?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 hschaa over 14 years ago in reply to BAlfson

Isn't that the port+address the RED uses to do its magic?

Correct. This is used to setup the control connection between the AP and ASG. Port 2712 is then used to tunnel frames from the AP to the ASG using the RED protocol.

Helmut
Cancel
Vote Up 0 Vote Down

Cancel