This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Full Transparent Mode

Hi people

Issue is about full transparent mode, when enable web protection in full transparent mode for network 10.93.0.0/24
It does not work properly . In picture you can see my routing config .

Utm doesn't have internet on wan ip address.

But in next steps router give internet to 10.93.0.0/24

do you have any idea??

This thread was automatically locked due to age.

Parents

0 BAlfson over 9 years ago

Hi, Nima, and welcome to the UTM Community!

What do you mean by "route 10.93.0.0/24 to 192.168.0.2?" Please insert a picture of your static route.

Do you have a masquerading rule for 10.93.0.0/24 in the router to the internet?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 NimaMirzaei over 9 years ago in reply to BAlfson

Hi BAlfson , thank you for welcoming and sorry for my latency.
I mean:
ip route 10.93.0.0 255.255.255.0 192.168.0.2
About masquerading I should say yes .
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 NimaMirzaei over 9 years ago in reply to BAlfson

Hi BAlfson , thank you for welcoming and sorry for my latency.
I mean:
ip route 10.93.0.0 255.255.255.0 192.168.0.2
About masquerading I should say yes .
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BAlfson over 9 years ago in reply to NimaMirzaei

Router B also needs a gateway route 10.93.0.0/24 -> 172.16.0.2. There must be no masquerading rule in router A or the UTM, but there must be a masq rule in router B like '{10.93.0.0/24} -> {WAN connection}'. In Full Transparent mode in the UTM, 10.93.0.0/24 must be in 'Allowed Networks'.

Are all of those in place? if so, then try #1 in Rulz - community.sophos.com/.../74722

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel