This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configuring http and other proxies with seperat internet interfaces

HI,
I have merged two UTMs, one uses IPv6 sixxes tunnel and the other used a native IPv6.
I have setup the connctions on two seperate interfaces and have internet access through the new link with policy routing and firewall rules.

How do I setup the connections so that traffic from the seperate zone goes out the link with the native IPv6 through the http proxy?

Ian M

This thread was automatically locked due to age.

0 Scott_Klassen over 10 years ago

If it were me, I'd use Uplink Balancing and Multipath Rules to achieve this.
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 10 years ago in reply to Scott_Klassen

Back to square one, my configuration broke mail. So, I will try the path you have suggested.

Ian[[[:)]]][[[:)]]][[[:)]]]
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 10 years ago in reply to RFCat_vk_01

I tried uplink balancing and multi-path rules which worked fine for about 15 minutes then mail failed along with internet becoming very slow on all interfaces. Deleting configurations doesn't work, I had to install and old config file, then start slowly again.

The bug with the multi-path tab and not being able to dis-able multi-path without deleting the interfaces is still there. I was under the impression this was fixed many versions ago? Yes, you can turn it off, but that does not disable it.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 10 years ago in reply to RFCat_vk_01

I have come to the conclusion that what I am trying to do does not work.

So, it is back to two UTMs.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel