This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Filtering RED in bridged mode

Hi all,

I just setup my UTM so briged my REDs to the branches use the same IP address of the HQ.

Its ok, but know I have an issue because the UTM not web filtering my REDs in standard/split, its filtering only if the RED as in standard/unified.

Anyone know how to solve it to I got web filtering using RED in the standard/split mode ?

thx.

Marc

This thread was automatically locked due to age.

Parents

0 Marc M over 10 years ago

Hi Umpf, thx by your reply.

Using the (Non)transparent and the transpartent with AD-SSO the both if I remove the proxy the machines behind RED can be access the internet without filter.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Marc M over 10 years ago

Hi Umpf, thx by your reply.

Using the (Non)transparent and the transpartent with AD-SSO the both if I remove the proxy the machines behind RED can be access the internet without filter.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 ManuelKarl over 10 years ago in reply to Marc M

Marc M:
Is the RED setup in unified mode? This should be essential, if split is configured, the clients are routed via the other gateway, only packets intented for your internal (central) Network are then handled by red!

Please check, thx.
Cancel
Vote Up 0 Vote Down

Cancel