This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HTTP/S Proxy Profiles on ASG 320

Hi !

I´ve been trying to configure a Proxy Profile. I configured a Profile with one source network (172.x.x.x for example), including a Filter assignment with two Active Directory (AD) users in 1 group. The Filter of these users doesn´t have any block URL sites while the Fall Back Action has another filter action (this one block almost all sites ).

It´s suppose that these 2 AD users can see all sites (Filter Assignment). Instead they´re blocked by the Fall Back Action. The proxy is in Transparent mode.

Can someone help me please ?? any advice....

This thread was automatically locked due to age.

0 BAlfson over 15 years ago

Samuel, this KnowledgeBase article might help: https://support.astaro.com/support/index.php/User_Contributed:HTTP/S_Proxy_Access_with_AD-SSO

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 samuel.lao85 over 15 years ago

OK...I could configure the proxy profile. Now, when you set IP Networks on each Proxy Profile, what about the EXAMPLE (USER NETWORK) " Known IP addresses for EXAMPLE unresolved " ?

could you use this parameter as a NETWORK IP for proxy profile??
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 15 years ago

The 'Username (User Network)' objects aren't resolved unless the user is connected via VPN or is logged-in to WebAdmin. I don't remember if it's resolved when the user logs into the End User Portal. If you are using "AD-SSO" or "Basic User Authentication", you don't need to use IPs for Profiles.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel