This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HowTo? Segregate 2 LAN's both using the HTTP Proxy?

Currently I have:
WAN: eth0
LAN1: eth1 192.168.1.0/24
LAN2: eth2 192.168.2.0/24
And I have an HTTP Proxy Profile setup for each (separately)

The problem I've been having is that even though I have Pack Filter rules that say to drop traffic going from LAN1 to LAN2 and vise-versa the proxy still lets you browse to 192.168.1.0 webservers from LAN2 & 192.168.2.0 webservers from LAN1.

I tried setting up some creative NAT'ing rules... but it didn't seem to make a difference..
Anyone know how I could pull this off?

Thanks...

This thread was automatically locked due to age.

Parents

0 BarryG over 18 years ago

You'll need to setup proxy profiles with rules to block the servers.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 kury over 18 years ago in reply to BarryG

Barry I've never needed to use a generic proxy and I'm not really sure where/when they are used... Would you mind explaining the settings I would need for such a setup as mine?

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 spoon404 over 18 years ago in reply to kury

when using the proxy, wouldn't all traffic look like it's comming from eth0?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 spoon404 over 18 years ago in reply to kury

when using the proxy, wouldn't all traffic look like it's comming from eth0?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data