VPN: Site to Site and Remote Access Route single host internet traffic via IPSEC remote gateway

UTM Firewall requires membership for participation - click to join

Thread Info

State Not Answered
Locked Locked
Replies 7 replies
Subscribers 2 subscribers
Views 10156 views
Users 0 members are here

Options

Suggested

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Route single host internet traffic via IPSEC remote gateway

RobertGareh over 9 years ago

Hello,

I've set up a s2s IPSEC tunnel beween 2 UTM9

Site 1 - 10.0.0.0/24 (UTM=10.0.0.1)

Site2 - 192.168.0.0/24 (UTM=192.168.0.1)

Both sites can see each other perfectly.

What i would like to do is have internet bound traffic from 10.0.0.4 routed over the ipsec tunnel and out via the gateway on the remote side.

I have tried configuring this in Policy routes, but it's not working for me.

Any pointers?

Thanks

This thread was automatically locked due to age.

Parents

0 sachingurung over 9 years ago

Hi Robert,

Configure a MASQ rule and firewall rule (VPN to WAN) for the specific IP Address for which you want to allow internet traffic.

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 RobertGareh over 9 years ago in reply to sachingurung

I should have said - I already had the masq rules and firewall rules in place on the remote side...

This is what my local site has configured:
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 RobertGareh over 9 years ago in reply to sachingurung

I should have said - I already had the masq rules and firewall rules in place on the remote side...

This is what my local site has configured:
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Share Feedback

×

Submitted a Tech Support Case lately from the Support Portal?