This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Red 10 VPN and Site to Site VPC Amazon

Hi,

I´ve a SG 125 and Site to Site configured to VPC Amazon and works fine. There is also a RED 10 configured to my SG 125 and works fine even I use SSL VPN client and works fine and connects to RED but I can not route traffic from/to REDVPC Amazon and/or SSL client to VPC Amazon

I use a wan interface called WANVPN for those porpouses

Red 10 network: 192.168.155.0/24
SSL VPN Network: 10.242.2.0/24
SG125 has 192.168.157.70
VPC Amazon 172.30.0.0

Any idea?

Regards

This thread was automatically locked due to age.

0 BAlfson over 9 years ago

The concepts are similar to How to allow remote access users to reach another site via a Site-to-Site Tunnel and hub & spoke /help. As you will see, the trick is to add the right local and remote networks in the right places.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 Edgar_Quintana over 9 years ago in reply to BAlfson

HI BAlfson,

Following your post I could repair the routing from/to SSL VPN clientsSG 125VPC AMAZON. But I still have problems with RED devices.

More ideas?

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 9 years ago

'Split networks' in the RED 10 configuration should contain "VPN Pool (SSL)," "Internal (Network)" and the subnet in the VPC. It's not clear whether you're using the UTM's 'Amazon VPC' capability with redundant tunnels or a regular IPsec Connection - which are you using?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel