This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Site to Site UTM 9 with ASA 5510

hi alltogether,

i have a sophos utm 9 on the one side and on the other i have a Cisco ASA 5510. They are connect over an IPsec tunnel with AES-256 PFS

The VPN Tunnel is working.

But after the 24h disconnect on the side of the ASA, the VPN Tunnel isn't connect anymore. In the webinterface of the UTM i still get the message that the tunnel is connected.
I have to restart the UTM 9 and everything is working again, till i have the next 24h disconnect.

Can you please help me.

This thread was automatically locked due to age.

0 bsloan9858 over 9 years ago

Not an answer but a question for you, does the ASA full tunnel back to the UTM? I'm looking to do the same.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 9 years ago

Have you selected DPD on the Cisco? If so, then what happens if you use a "Respond Only" Remote Gateway definition in the UTM for the Cisco site?

Yes, it's possible to do a full tunnel with the UTM.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel