This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Load Balancing to VPN

Hi,

I am a bit of a newbie and looking for some help with my setup.

I have successfully setup the Amazon VPC and can access the Amazon VPC private subnet from any device on my network.

However, on my UTM device, I now want to setup HTTP load balancing to port 80 and cannot seem to figure out how to do it. I want my virtual server to be a public IP address that is on my network and load balance the traffic to servers on my Amazon private subnet.

I have setup a simple load balancing rule as in my attachment, and it does not seem to function.

I'd appreciate some pointers on what I have to do to get this to function correctly.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

UUUggghhh, VPC.

Need some clarification. Here's how I'm interpreting your post. You are hosting a couple of web servers, that you want to be accessed via an additional address assigned to the WAN of the UTM. You want your internal clients to access these servers via Server Load Balancing. Does this sound correct?

Traditionally, for internal clients to access your own WAN IPs, you would need to a Full NAT rule. https://www.sophos.com/en-us/support/knowledgebase/115191.aspx. You may also want to take a look at the thread here: https://community.sophos.com/products/unified-threat-management/astaroorg/f/54/t/42272.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

UUUggghhh, VPC.

Need some clarification. Here's how I'm interpreting your post. You are hosting a couple of web servers, that you want to be accessed via an additional address assigned to the WAN of the UTM. You want your internal clients to access these servers via Server Load Balancing. Does this sound correct?

Traditionally, for internal clients to access your own WAN IPs, you would need to a Full NAT rule. https://www.sophos.com/en-us/support/knowledgebase/115191.aspx. You may also want to take a look at the thread here: https://community.sophos.com/products/unified-threat-management/astaroorg/f/54/t/42272.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data