This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cisco ASA to UTM 9.211-3

Need some help, I believe I have the tunnel setup right but I am not getting past phase 1 in creating the tunnel.

The last line I am getting in the log looks like this

#1: received Delete SA payload: deleting ISAKMP State #1

My question is this, is there any documentation on setting up a tunnel from a UTM to a Cisco ASA?

Thanks

This thread was automatically locked due to age.

Parents

0 BarryG over 10 years ago

Hi, you just need to make sure you get all the policy settings to match on both ends.

IIRC, compression does not work with some Cisco devices.

The policy I'm using on the UTM is below.

Barry
- ipsec.png
- View
- Hide
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 10 years ago

Hi, you just need to make sure you get all the policy settings to match on both ends.

IIRC, compression does not work with some Cisco devices.

The policy I'm using on the UTM is below.

Barry
- ipsec.png
- View
- Hide
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data